Olympus OTV-SI - Page 96

90
Chapter 5 Operation
VIDEO SYSTEM OTV-SI
5. Press the remote control switch for execution, the “Enter”, “  ” or “  ” key
on the keyboard to change the iris mode.
6. Select “MES [ ]” for the center-screen mode (CENTER) and select
“MES [ ]” for the full-screen mode (FULL).
 Using the remote control switch that is assigned to
“MES[ ]”
1. Assign the “MES[ ]” function to one of the remote control switches on the
videoscope or camera head following the instructions given in Section 5.9,
“Remote control switches”.
2. Press the remote control switch for “MES[ ]”. Every time the remote control
switch is pressed, the center-screen mode (CENTER) and the full-screen
mode (FULL) are alternated.
• When the menu is not displayed, pressing the remote control
switch for “MES[ ]” displays the following words at the
bottom left of the video monitor screen.
• The iris mode is retained when the video system is turned
OFF and turned ON again.
MEASURE [CENTER] : When the center-screen mode is
selected.
MEASURE [FULL] : When the full-screen mode is
selected.
VISY218