Erasing pictures
79
5
Playback
This function erases recorded pictures. Pictures can be erased either one
at a time or all the pictures in the internal memory or on the card.
1 Select the picture you want to
erase, and press the S button.
g“Direct buttons” (P. 12)
2 Select [YES], and press Z.
• The displayed picture is erased.
Note
• If there is not enough space left on the card, [CARD FULL] is displayed and
backup is canceled.
• When the f mark is blinking, pictures cannot be backed up because of
insufficient battery power.
• If the battery power runs out while the camera is backing up the data, the image
data may be lost or damaged. It is recommended that you use the AC adapter.
• Never open the battery compartment/card cover or remove the battery while
the camera is backing up data. Also, do not connect or disconnect the AC
adapter. The internal memory or the card may not operate properly.
Note
• You cannot erase protected pictures. Cancel protection before erasing such
pictures.
• Once erased, pictures cannot be restored. Check each picture before erasing
to avoid accidentally erasing pictures you want to keep. g“Protecting
pictures” (P. 78)
• When a picture in an album is erased, it is also erased from the album.
Single-frame erase
Erasing pictures
OK
ERASE
YES
NO
SELECT
GO
To Next Page
Loading...
