Olympus STYLUS 600 - Adjusting the Image Processing Function (PIXEL MAPPING)

Adjusting the image processing function (PIXEL MAPPING)
87
6
Settings
Top menu [MODE MENU] [SETUP] [FILE NAME] [RESET] / [AUTO]
g“Using the menus” (P. 17)
The pixel mapping feature allows the camera to check and adjust the CCD
and image processing functions. It is not necessary to operate this function
frequently. Approximately once a year is recommended. Wait at least one
minute after taking or viewing pictures to allow the pixel mapping function
to perform properly.
Top menu [MODE MENU] [SETUP] [PIXEL MAPPING]
g“Using the menus” (P. 17)
1 Press Y. When [START] is
displayed, press Z.
• The [BUSY] bar is displayed during pixel
mapping. When pixel mapping is
finished, the screen returns to the mode
menu.
Note
• When the File No. reaches 9999, the file number returns to 0001 and the folder
number changes.
• When both the folder number and file number reach their respective maximum
number (999/9999), the number of storable pictures becomes 0 even if the card
is not full. Replace the card with a new one.
Note
• If you turn the camera off during pixel mapping, start again from Step 1.
Adjusting the image processing function
(PIXEL MAPPING)
START
FILE NAME
PIXEL MAPPING
SETUP
MEM CAM
DUAL TIME
SETUP