Olympus U-5RES-ESD

To Next Page

To Previous Page

Fig. 2

Fig. 1

Note 1)

RS-232C cable specifications

D-sub 9-pin (female)

Note 2)

When connecting a cable to the BX3-RFAS, U-D7RES, U-5RES-ESD or

U-D5BDRES-ESD connector, align the t markings @ on the connectors

of the cable and the U-CBS (Fig. 1).

Note 3)

Hang the U-CBS control box 2 on the hangers 3 on the rear of the

microscope frame (Fig. 2).

} When using coded revolving nosepiece (U-5RES-ESD, U-D5BDRES-ESD),

place U-CBS on the table. Refer to manual of coded revolving nosepiece.

Note 4)

When this system is used with the DP21 microscope digital camera, set

the power switches to ON in the order of: @ U-CBS and 2 DP21-CB.

Otherwise, the DP21 will not recognize the U-CBS. Also if the U-D7RES,

U-5RES-ESD or U-D5BDRES-ESD are not connected to the U-CBS, the

DP21 will not recognize it either. So be careful.

Olympus U-5RES-ESD - Page 8