Olympus U-5RES-ESD - Cable Distributions

6
CODED FUNCTION SYSTEM
3
3
CABLE DISTRIBUTIONS
} The cables can be laid properly by attaching the cable holders provided with each module on the rear panel of the
microscope frame.
U-CBS control box .......... x6
U-D7RES coded revolving nosepiece .......... x2
U-5RES-ESD coded revolving nosepiece .......... x4
U-D5BDRES-ESD coded revolving nosepiece .......... x4
U-LS30AD adapter .......... x1
· In the subsequent pages, the positions for attaching the cable holders and the method of cable distribution will be
described for each microscope system.
· The number of the cable holders used vary depending on the modules used in the system.
· If the cable holders are attached in widely deviated positions, the cable may become unable to reach the connector. Be
sure to attach the cable holders while confirming that their positions allow the cable to reach the connector
· Be sure to remove cable slacks before closing the cable holders.