13
U-HGLGPS
n PROPER SELECTION OF THE POWER CORD
If no power cord is provided, please select the proper power cord for the equipment by referring to “ Specifications ” and “ Certified Cord ” below:
CAUTION: In case you use a non-approved power cord for Olympus products, Olympus can no longer warrant the electrical
safety of the equipment.
Specifications
Voltage rating
Current rating
Temperature rating
Length
Fittings configuration
125V AC (for 100-120V AC area) or, 250V AC (for 220-240V AC area)
6A minimum
60˚C minimum
3.05 m maximum
Grounding type attachment plug cap. Opposite terminates in molded-on IEC con-
figuration appliance coupling.
Table 1 Certified Cord
A power cord should be certified by one of the agencies listed in Table 1 , or comprised of cordage marked with an agency
marking per Table 1 or marked per Table 2. The fittings are to be marked with at least one of agencies listed in Table 1. In
case you are unable to buy locally the power cord which is approved by one of the agencies mentioned in Table 1, please
use replacements approved by any other equivalent and authorized agencies in your country.
Country Agency
Certification
Mark
Country Agency
Certification
Mark
Argentina
IRAM Italy IMQ
Australia SAA Japan
JET, JQA, TÜV,
UL Japan/METI
Austria ÖVE
Netherlands KEMA
Belgium CEBEC Norway NEMKO
Canada CSA Spain AEE
Denmark DEMKO Sweden SEMKO
Finland FEI Switzerland SEV
France UTE
United
Kingdom
ASTA
BSI
Germany VDE U.S.A. UL
Ireland NSAI
To Next Page
Loading...
Need help?
General
