Olympus U-SDO3 - Attaching BX3-MDOE; Attaching the Stand

23
4
Attaching BX3-MDOE
Tighten the clamping screw
c
to secure BX3-MDOE to U-MDOSV.
Attach BX3-MDOE so that the clamping screw
c
of U-MDOSV
and the clamping screw
d
of BX3-MDOE are aligned in one line
perpendicularly.
2
c
d
a
b
1
Attach BX3-MDOE
b
to the tube mount
a
on U-MDOSV.
1
5
Attaching the stand
Place U-MDOSV on the desk upside down and screw the
b
portion
of the stand into the mount screw hole
a
of U-MDOSV.
1
a
b
c
1
2
Rubber leg position
2
Rubber leg position
Loosen the stand height lock knob
c
. Rotate the
portion shown
in the picture and place one of three rubber legs attached to the
back side of the base of the stand so that it is parallel to the tube of
U-MDOSV as shown in the picture.
2