12
1
If you set the date and time beforehand, the information when the file is recorded is automatically
stored for each file. Setting the date and time beforehand enables easier file management.
Setting Time/Date (Time&Date)
Setting Time/Date (Time&Date)
1
Press the 9 or 0 button to
select the item to set.
Select the item from “hour”, “minute”, “year”
“month” and “day” with a flashing point.
2
Press the + or
–
button to set.
Follow the same steps by pressing the 9
or 0 button to select the next item, and
press the + or – button to set.
3
Press the OK button to complete
the setup screen.
The clock will start from the set date and
time. Press the OK button according to the
time signal.
• You can choose between 12 and 24 hour
display by pressing the FOLDER/INDEX
button while setting the hour and minute.
Example: 5:45 P.M.
5:45 PM ←→ 17:45
(Initial setting)
The hour indicator will flash automatically when you load a battery
before using the recorder for the first time, or after the recorder
hasn’t been used for a long time. Proceed from step 1.
1
2
3
To Next Page
Loading...
Need help?
General
