,
IIi
30
Disconnecting from Your PC
1
Click
the
~
on
the
task
bar
• located at the lower-right
corner of the screen. Click
[Safely Remove Hardware].
The drive letter will differ
depending on the
PC
being used.
When the safe to remove hardware window appears, click [OK].
3Make
sure
that
the
display
is
turned
off,
disconnect
the
USB.
II
Connect the battery compartment to the main unit.
i Leave the HOLD switch
in
its disabled position
(1&
P.37) when connecting
, the battery compartment.
Notes
• NEVER disconnect the USB while the record/play indicator light and USB access indicator light are flashing
in
red. If you do so, the data may be destroyed.
• Refer to the user's manual for your
PC
regarding the USB port or USB hub
on
your PC.
•
Be
sure to push the USB connector
811
the way in. Otherwise, the recorder may not operate properly.
• Use the supplied USB extension cable depending on situations.
•
Do
not use USB extension cables other than the supplied cable. Using cables from other manufacturers
could result
in
damage to the recorder. Do not use the supplied USB extension cable with devices from
other manufacturers.
To Next Page
Loading...
