R
8
• Manganese battery may not be used
in
this recorder.
• Be sure to stop the recorder before replacing the battery. Unloading the battery while the recorder is in
use may corrupt the file. If you are recording into a file and the battery runs out, you will lose your currently
recorded file because the file header will not be able to close. It
is
crucial to change the battery once you
see only one hash mark in the battery indicator.
• If it takes longer than 15 minutes to replace the dead battery or if you take the battery
in
and out repeatedly
at short intervals, you may have to reset the time when you have loaded a fresh battery.
• Remove the battery if you are not going to use the recorder for
an
extended period of time.
• When playing a voice/music file, the recorder may be reset due to the reduction of the voltage output of
the battery depending
on
the volume level even if
~r
••
1is displayed
in
the battery indicator.
In
this case,
lower the volume of the recorder.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
