Omega OAL-100 - Motor and Control Board Wiring

OMEGA AUTOMATICS 2020 v3.0.2 10
Fig 7.2.2
✓ For push application mount the unit bottom flush with the bottom of the frame
✓ For pull application mount the bottom of the unit on top of the frame (2" above the top of the door).
Fig 7.2.3
✓ Install the gearbox aligned with marks using appropriate fasteners.
✓ Install control board on back plate using appropriate fasteners.
Fig 7.2.4
7.3 Motor and control board wiring
✓ Connect motor wire to motor connector on controller.
✓ Connect limit switch wire to limit connector on controller.
Door frame
or