Omega OAL-100 - Hardware as Shipped; Safety Information; Safety Instructions; Safety Warnings

OMEGA AUTOMATICS 2020 v3.0.2 7
3.3 Hardware as shipped
3.3.1 Single swing door
1. Box containing surface mount header assembly for one OAL-100 operator. Included inside header:
Surface Mount
OHC (Over Head Concealed)
In Ground
Motor Gearbox
Motor Gearbox (Spline/ Square
spindle)
Motor Gearbox
Control Board
Control Board
Control Board
Arm Assembly Kit
Center Spindle Arm Assembly Kit
Square Spindle Jockey Box
Center Hung Top Arm
Bottom Arm
3.3.2 Double swing door
1. Box containing surface mount header assembly for two OAL-100 operators. Included inside header:
Manual and Auto (Surface
Mount)
Manual and Auto (OHC or In
Ground)
Double Auto
1 Motor Gearbox
Motor Gearbox (Spline/ Square
Spindle)
2 Motor Gearboxes
1 Control Board
Manual Door Closer Dorma RTS 88
2 Control Boards
2 Arm Assembly Kits
Center Spindle Arm Assembly Kit
or Center Hung Top Arm
2 Arm Assembly Kit (depends on
the type of the operator)
Mount Plate for Manual Door
Closer (LCN4040)
In Ground Bottom Arm
4. Safety information
4.1 Safety Instructions
This document contains important instructions for installation of the OAL-100 swing door operators. Renew these
instructions thoroughly prior to installation and follow them carefully during installation commissioning, troubleshooting
and maintenance.
4.2 Safety warnings
❖ Damage to equipment or incorrect equipment operation may result from an incorrect installation.
❖ Hazard to mechanical processes by use of control settings elements or procedures not documented in this manual!
❖ Electric shock hazard!
❖ By use of control elements, settings of Procedures not documented in this manual!
❖ Work on electrical equipment and 115 VAC wiring installation must be performed only by qualified personnel!
❖ Metallic doors must be grounded per national and local codes!