Omega OAL-100 - OAL-100 Installation Process; Unpack and Remove Cover; Install Bottom Track on Wall

OMEGA AUTOMATICS 2020 v3.0.2 9
7. OAL-100 installation process
7.1 Unpack the box and take out cover
✓ Use 1/8" allen key to take out cover screws
Fig 7.1.1
7.2 Installation of bottom track on the wall
✓ Mark the location of the motor on back plate
✓ Use 1/4" allen key to take out gearbox fasteners and remove gearbox
✓ Use 1/4" allen key to take out controller fasteners and remove controller
Fig 7.2.1
✓ Use drill with drill bit that matches screw size to drill for mounting screws.
✓ Always drill between channels
✓ Drill at least 6 holes on gearbox side and 4 on controller side