11
INSTRUCTIONS FOR USE Cont.
Electronic Control
Control Panel Description
(Models: OO686X, OO687X)
The oven control panel is made with one display and two knobs.
- Time & Temperature display.
- Time & Temperature knob (Push & Shuttle).
- Mode (oven functions) knob.
The push & shuttle knob is mainly for clock or temperature setting and automatic time functions programming.
Select the desired item by pushing the knob.
Programming time functions
At every power-up, the control shows the time of day blinking, set at 12:00 as the initial value. The time
increases every minute. The only possible action is the “Clock Regulation”, all other oven operations are
inhibited.
In general, turn the Temp/Time selector left or right in order to edit the values and modify them by steps; hold
the knob on the left or right to fasten the decrease/increase operations.
Setting the time of day
The time of day is always displayed in the 24 hours format. Hours and minutes are set separately.
In order to set the time of day, mode selector must be in ZERO position, the -/+ knob acts on the time of day
by default.
- Turn the selector left/right, the hours flash.
- Modify the flashing hours value turning the selector left/right.
- Push the Temp & Time selector to switch back and forth between hours and minutes.
- Modify the flashing minutes turning left/right.
- After a few seconds the whole time of day value starts flashing: wait until the new time of day is steady.
Push the knob to toggle between the time of day and the minute minder and check the set values. The clock
is selected by default while the symbol appears when the minute minder is displayed.
To Next Page
Loading...
