13
INSTRUCTIONS FOR USE Cont.
4. When the word dur is displayed, the control shows 30’ as the standard cooking duration.
Turn the knob left/right in order to set the actually desired cooking time in a range between 0 and 240
Minutes. The display will flash dur and its value alternatively for a few seconds then it will show the time of
day, the pot symbol and the letter to indicate that a timed cooking is active. The end of cooking time is
updated automatically.
5. When the word End is displayed, the control shows the current time as the initial stop time. In order to set
the actually desired end of cooking time in a 24 hours range:
- Turn the knob left/right, the hours flash.
- Modify the flashing hours value turning the knob left/right.
- Push the knob to switch back and forth between hours and minutes or wait a few seconds until the minutes
flash.
- Modify the flashing minutes value the knob left/right.
- Wait until the new End of Cooking time value stops flashing.
The display will flash End and its value alternatively for a few seconds then it will show the time of day, the
symbol and the letter to indicate that a timed cooking is active. The cooking duration is updated automatically.
3. Repeat the same operations of point 1 then push the knob until End appears. The control shows the
“current time + cooking time” as the initial stop time. It’s not possible to lower the end of cooking time below
this value. In order to set the actually desired end of cooking time in a 24 hours range:
- Turn the knob left/right, the hours flash.
- Modify the flashing hours value turning the knob left/right.
- Push the knob to switch back and forth between hours and minutes or wait a few seconds until the minutes
flash.
- Modify the flashing minute’s value turning the knob left/right.
- Wait until the new End of Cooking time value stops flashing.
The display will flash End and its value alternatively for a few seconds then it will show the time of day and the
letter to indicate that a delayed cooking has been programmed. As soon as the delay time expires, the oven
starts and works for the programmed cooking time. The symbol is displayed.
At the end of any timed activity the control shuts down the oven, the buzzer sounds a warning sequence (two
short beeps repeated every 3 seconds) to recall the user attention, for a maximum time and makes the time
related icons ( , ) flash on the display. Push the knob to silent the buzzer and reset the warning message.
Turn the mode selector to ZERO (OFF) position before reusing the oven.
Oven functions
The control can manage many cooking functions, here below described, their number and availability
depends on the oven model. The temperature range is between 50°C and 250°C for most functions.
Preset temperatures are mainly 190°C for convection modes, 210°C for thermal modes and 230°C for grilling
functions.
Exceptions are Eco-Bake (preset=190°C) and low temperature modes (Light, Defrost, Keep Warm).
Eco-Bake
This function is defined in order to obtain a consistent energy saving. The cooling fan is initially off and turns
on only when the inner parts temperature gets high. Cooking might be a little bit slower than the standard
Bake, especially when the oven is heavily loaded.
To Next Page
Loading...
