Omega Platinum DP32Pt - Operating Mode Menu (Oper)

PLATINUM
TM
Series Meters Quick Start Guide
17
Complete Menu Structure
5.3 Operating Mode Menu (oPER)
The following table maps the Operating Mode (oPER) navigation:
Level
2
Level
3
Level
4
Notes
RUN
Normal Run Mode, process value displayed, SP1 in optional secondary display
SP1
____
Shortcut to change Setpoint 1, current Setpoint 1 value in main display
SP2
____
Shortcut to change Setpoint 2, current Setpoint 2 value in main display
MANL
M.CNt
____
Manual Mode, the RIGHT and LEFT buttons control output, displays M##.#
M.INP
____
Manual Mode, the RIGHT and LEFT buttons simulate the input for testing
PAUS
Pause and hold at current process value, display flashes
StoP
Stop controlling, turn off outputs, process value rotating flash, Alarms remain
L.RSt
Clears any latched Alarms; Alarms menu also allows digital input reset
VALy
Displays the lowest input reading since the VALy was last cleared
PEAk
Displays the highest input reading since the PEAk was last cleared
Stby
Standby Mode, outputs, and Alarm conditions disabled, displays Stby
tARE
TARE option - only available if enabled in INPt