Omega RDXL4SD - Auto Datalogger

5-2 Auto Datalogger (Set sampling time ≥ 1 second )
a. Start the datalogger
Press the “REC Button (3-4, Fig. 1) once , the LCD will
show the text “REC”, then press the “Logger Button”
(3-8, Fig. 1), the “REC” will flash and the beeper will
sound at the same time the measuring data along with
the time information will be saved into the memory circuit.
Remark :
*
How to set the sampling time, refer to Chapter 7-6,
page 19.
*
How to enable the beeper sound, refer to
Chapter 7-4, page 18.
b. Pause the datalogger
During execute the Datalogger function, press the
“Logger Button” (3-8, Fig. 1) once will pause the
Datalogger function (stop to save the measuring data
into the memory circuit temporally). At the same time
the text of " REC " will stop flashing.
Remark :
If you press the “Logger Button” ( 3-8, Fig. 1 ) once again,
it will execute the Datalogger again, the text of “REC” will
be flashing .
c.. Finish the Datalogger
To pause the Datalogger, press the “REC Button”
( 3-4, Fig. 1) continuously for at least two seconds, the “REC”
indicator will disappear and stop the Datalogger.
11