Omega RDXL4SD - Manual Datalogger; Check Time and Sampling Information

5-3 Manual Datalogger (Set sampling time = 0
second)
a. Set sampling time is to 0 second
Press the “REC Button” (3-4, Fig. 1) once , the LCD will
show the text “REC”, then press the “Logger Button”
( 3-8, Fig. 1 ) once, the “REC” will flash once and the
Beeper will sound once, at the same time the measuring
data along the time information and the Position no. will
be saved into the memory circuit.
Remark :
* For the 4 channels measurement, the right lower
Display will show the Position/Location no. (P1, P2...
P99) and the T4 measurement value alternately.
* During execute the Manual Datalogger, use
the “▲” Button (3-5, Fig. 1) or “▼” Button (3-6,
Fig.1) to set the measuring position (1 to 99, for
example room 1 to room 99) to identify the
measurement location.
b. Finish the Datalogger
Press the “REC Button” (3-4, Fig. 1) continuously at
least two seconds, the “REC” indication will be
disappear and stop the Datalogger.
5-4 Check time information
During the normal measurement (not execute the
Datalogger). If you press “Time check Button” (3-7, Fig. 1)
once, the lower LCD display will present the time
information of Year/Month, Date/Hour, Minute/Second.
12