OMNI-624/OMNI-624EU Installation and Setup Guide
5-6
STAY ARMING
TO ARM:
Press the [
STAY
] key followed by a four-digit user code.
This will arm the system with all programmed interior zones bypassed.
OMNI-LCD OMNI-KP XK-108L/XK-108
Indicator LED Lit Armed Armed Armed, Stay
Display ON: STAY STAY N/A
INSTANT ARMING
TO ARM:
Press the
[
INSTANT
] key followed by a four-digit user code. The
INSTANT
and
ARM
LEDs
will light continuously.
OMNI-LCD OMNI-KP XK-108L/XK-108
Indicator LED Lit Armed Armed Armed, Instant
Display ON: INSTANT INSTANT N/A
The entire security system (interior and exterior) is armed at this time, eliminating the entry time
delay(s) that have been programmed into the system.
NOTE:
The Instant mode can be enabled through programming Submode 1, Question 14, Location 1.
STAY/INSTANT ARMING
TO ARM:
Press the [
STAY
]
key; press the [
INSTANT
] key and enter a four-digit user code.
The
STAY/INSTANT
mode will arm the system with the characteristics of both the
STAY
and
INSTANT
modes. The keypads will have the
ARM
,
INSTANT
and
STAY
LEDs turned ON
continuously.
OMNI-LCD OMNI-KP XK-108L/XK-108
Indicator LED Lit Armed Armed
Armed, Instant,
Stay
Display ON: STAY/INS STAY
INSTANT
N/A
The system will be armed with the interior zones bypassed and the delay zones instant.
NOTE:
The STAY/INSTANT mode can be enabled through programming Question 14, Location 1.
DISARMING
TO DISARM
: Enter any valid four-digit user code and the
ARM
LED will extinguish.
If an alarm condition exists or occurred while the system was armed, the respective zone LED will
blink rapidly. This condition is classified as Alarm Memory, and can be cleared by entering a valid user
code again. Note that a user with level 4 authority (limited user) can disarm the system only if it was
armed by a lever 4 user.
To Next Page
Loading...
Need help?
General