Omni OMNI-624 User Manual

OMNI-624/OMNI-624EU Installation and Setup Guide
6-26
QUESTION 16 DISPLAY OPTIONS
L1 L2 L3 L4
This question defines display options. Enter the digits as follows:
Q 16, L1 – Enter the L1 digit from the table below.
L1
Entry
Armed Bypass
Display
Display Fault
On Entry
No AC Loss
Display
Manual
Bypass Limit 3
0
1
✔
2
✔
3
✔✔
4
✔
5
✔✔
6
✔✔
7
✔✔✔
8
✔
9
✔✔
A
✔✔
B
✔✔ ✔
C
✔✔
D
✔✔✔
E
✔✔ ✔
F
✔✔✔✔
Armed Bypass Display:
If
selected, pressing the [BYPASS]
key will scroll bypassed zones
while the system is armed.
Display Fault on Entry:
Display
faults (open zones) during entry
delay time.
No AC Loss Display:
If selected,
the AC loss message will not be
displayed on OMNI-LCD keypads.
Manual Bypass Limit 3:
If
selected, no more than 3 zones can
be manually bypassed.
Q 16, L2
– Enter the L2 digit from the table below.
L2
Entry
No
Code
Set
Time
Daylight
Saving
(Summer)
Time
Keypad
Extinguish
Keyfob
Low
Bat.
Display
0
1
✔
2
✔
3
✔✔
4
✔
5
✔✔
6
✔✔
7
✔✔ ✔
8
✔
9
✔✔
A
✔✔
B
✔✔ ✔
C
✔✔
D
✔✔✔
E
✔✔✔
F
✔✔ ✔✔
No Code Set Time:
If selected, allows Quick
Command #3 to set time. Intended for low-security
installations.
Daylight Saving (Summer) Time:
If selected,
the system will automatically adjust for daylight
saving (summer) time (U.S. standard: First
Sunday in April at 2:00 AM, the clock goes ahead 1
hour; last Sunday in October at 2:00 AM, the clock
goes back 1 hour to standard time).
Keypad Extinguish:
If selected, the keypad
display and LEDs will turn off after 1 minute of no
key presses.
Keyfob Low-Battery Display:
This option
determines whether low-battery messages from
keyfobs will be displayed. If selected, display is
enabled. Note that even if this display is disabled,
keyfob low-battery conditions can be checked by
using the #56 Quick Command.

Omni OMNI-624 Specifications

General

Brand	Omni
Model	OMNI-624
Category	Security System
Language	English