PAGE 10
Before you use the Omnilux clear-U
Some people are sensitive to light. If you are one
of these people, the Omnilux clear-U may not be
suitable for you. To determine if you are sensitive
to light, we recommend that you carry out a test
on your forearm.
1. ALWAYS switch the wall outlet socket off. If
you do not switch the outlet off there is a risk
that you may touch a live pin when plugging
the Wall Power Supply into the outlet.
2. PLUG the
power supply
mains cable into
the wall outlet
socket.
3. PLUG the
power supply
connector into
the Omnilux
clear-U.
4. SWITCH the
wall outlet
socket on.
5. OPERATE the selector switch on the front of
the Omnilux clear-U to turn on the red LEDs,
place the transparent lens of the Omnilux
clear-U in contact with or at a maximum of
1cm/0.5” from your upper forearm for 20
minutes. You should NOT experience any
adverse reaction during the next 24 hours.
An adverse reaction is any pain or discomfort
in the treatment area or any skin redness that
lasts for longer than twenty four hours.
If, after 24 hours, you have not experienced an
adverse reaction to the red light, repeat the test
on the other forearm BUT this time using the blue
light. If, after 24 hours, you have not experienced
an adverse reaction to the blue light it is safe
for you to use the Omnilux clear-U.
To Next Page
Loading...
