Omnilux CONTOUR - Omnilux Contour Face Overview; Intended Use; Device Description

8 9
•
Warnings
Before using Omnilux Contour Face, you must carry out a
sensitization test (see section 5.2 - page 10).
•
•
DO NOT use Omnilux Contour Face in any way that is not
exactly as specified in these instructions for use.
Use of the Omnilux Contour Face device other than exactly
as specified in these instructions for use has not been tested
and the risk is unknown.
TURN OFF and REMOVE the Omnilux Contour Face device
immediately if it feels hot or if your skin feels uncomfortably
warm. Omnilux Contour Face LEDs do not produce any heat.
• DO NOT use Omnilux Contour Face without first removing
creams, serums, lotions, and make-up BEFORE treatment.
Some ingredients in these products may cause light sensitizati
on or may reduce the effect of the treatment.
o If you use the Omnilux Contour Face device
without first removing these products, you may
cause a skin reaction, damage your device, or you
may reduce the effect of the LED treatment.
•
•
DO NOT use the Omnilux Contour Face device near water
or anywhere water can be spilt onto the equipment.
DO NOT use the Omnilux Contour Face device if you think
it may have come into contact with water.
Keep the Omnilux Contour Face device away from HOT
surfaces.
• DO NOT attempt to modify the Omnilux Contour Face device in
any way. Modifying the Omnilux Contour Face device will void
your warranty. Modifying the Omnilux Contour Face device could
cause an electric shock when the device is used again. The device
contains no serviceable parts.
• DO NOT use Omnilux Contour Face if the device, battery, or
charging plug are damaged in any way.
General safety
The Omnilux Contour Face device is an electrical
device, which under certain circumstances could present an electrical
shock hazard to the user. Please read the accompanying user manual
thoroughly and follow directions stated in the manual to assure
maximum safety during operation.
•
•
•
•
Precautions
The Omnilux Contour Face straps contain a mixture of
polyester, nylon and lycra. If you are allergic to any of these
materials, you may not be able to use the straps.
Omnilux Contour Face CANNOT be operated while it is in the
charging mode.
Before each use with the device turned off, clean the device. All
surfaces of the Omnilux Contour Face device may be cleaned
by following the cleaning instructions in Section 7.1. - page 11.
DO NOT use any other cleansing products other than those
stated in the cleaning instructions. Use of other cleansing
products may damage the Omnilux Contour Face device. Store
the Omnilux Contour Face device flat and at room
temperature in dry conditions, away from direct sunlight.
 4KUMUCPFbGPGƂVU
4.1. Potential adverse effects
•
Immediately after treatment, skin may appear red. Skin
should return to normal within 1-2 hours.
 2QVGPVKCNbGPGƂVU
• People who have undergone a course of 12 Omnilux
Contour Face treatments report a visible improvement
in skin tone and texture.
5.0. First time setup
5.1. Unpacking and charging your Omnilux Contour Face
The Omnilux Contour Face device uses a lithium-ion
polymer battery. When in the charging mode, the device will
not illuminate.
•
•
•
•
Before use, it is important to fully charge the Omnilux
Contour Face battery.
Unpack the Omnilux Contour Face device and check off
parts described in Section 2.0. - page 5.
To charge Omnilux Contour Face, insert the micro USB
cable into the controller. Insert the USB connector into the
USB port of the power supply.
Insert the power supply into a suitably grounded outlet and
press ON/OFF button on the controller.