10 11
• The 3 LEDs in the control unit will start to flash to indicate
charging. The Omnilux Contour Face battery is fully
charged when the three indicator LEDs on the battery
stay illuminated.
5.2. Sensitization test
Before carrying out your first treatment, you must carry out a
sensitization test. Follow the step by step guide below:
1. Place the Omnilux Contour Face device over your
inner arm.
2.Press the ON/OFF button on the controller until lights are
illuminated and allow device to run for its full 10-minute
treatment program.
3. At any time if your skin feels HOT or uncomfortable,
immediately turn OFF your device and remove from skin.
4. After the treatment, wait at least 6 hours. If your skin on
your inner arm is red or itchy then Omnilux Contour Face
is not suitable for you.
6.0. Using Omnilux Contour Face
6.1. Treatment recommendations:
•
•
For best results, treat for 3-5 days a week for a minimum
of 4 weeks.
Maintenance treatments should be carried out as desired,
according to lifestyle and skin condition.
6.2. Wearing Omnilux Contour Face
•
•
•
•
Omnilux Contour Face comes with adjustable straps
that allows you to comfortably wear the device on
your face.
To fit, thread the straps through the inlet
holes on either side of the device.
Loop the straps around the back of your
head and secure firmly.
Adjust if necessary.
6.3. Carrying out a treatment
1. Cleanse and exfoliate the face to remove any traces
of skincare
2. Place Omnilux Contour Face on the face and secure with
the straps provided and press ON/OFF button on the
controller. The device turns off after a 10-minute treatment.
You may stop the treatment at any time by pressing the
ON/OFF button on the controller.
3. Remove the device, apply your normal skincare and
sunscreen.
4. Clean the device using a water-based wipe or a damp clean
cloth. Ensure that the device is NOT being charged when
cleaning.
5. Repeat 3 – 5 days a week for a minimum of 4 weeks.
7.0. Care and maintenance
•
•
•
•
Store the Omnilux Contour Face device flat and at room
temperature in dry conditions. Use the carry bag provided to store
your device.
Avoid storing the Omnilux Contour Face device in dusty
conditions, in direct sunlight, or in damp and humid conditions.
The Omnilux Contour Face device contains no serviceable parts.
Before each use, with the device off, clean the device following the
cleaning instructions below.
DO NOT use any other cleansing products as these may
damage the plastics.
• Clean both sides of the Omnilux Contour Face device with
a water-based wipe or a damp clean cloth. Place
the mask on a clean dry surface to air dry.
Visually inspect the surfaces to ensure they are clean.
Stubborn stains can be removed by wiping gently with 70%
alcohol.
7.2. Disposal
DO NOT
dispose of any part of the device at a domestic
waste facility.
The Omnilux Contour Face controller contains a lithium-ion
polymer battery. For protection of the environment, please
package and return this unit to the manufacturer or their
representative at the end of its working life or safely dispose of
the device following your local guidelines.
7.1. Cleaning the Omnilux Contour Face device
To Next Page
Loading...
