10
2. Preparation
2.3
Setting the TruRead
TM
Mode
The TruRead
TM
Mode takes 3 consecutive measurements. The monitor will inflate,
take a measurement, and deflate - 3 times, separated by a short interval between
each measurement. The TruRead
TM
Mode is set “oFF” by default
.
1. Select your USER ID (1 or 2).
2. Press the button.
The TruRead
TM
symbol ( ) appears on the display.
3. To set the date and time, proceed to section 2.4.
If the date and time are correct, press the START/STOP button to turn the monitor off.
1)
3)
2)
4)
Press the button to confirm.
If “on” is selected the interval setting appears.
Press
or
buttons to select “on” or
“oFF”.
Press
or
buttons to change the interval.
It can be set 15, 30, 60, or 120 seconds.
Press the button to confirm.
To Next Page
Loading...
Need help?
General
