EasyManua.ls Logo

Omron CS Series Operator's Manual

Omron CS Series
274 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #122 background imageLoading...
Page #122 background image
Step Run and Break Section 4-3
107
I/O Break Condition
The I/O break condition is expressed with the following elements for both I/O
Condition and Word Condition.
<Target I/O memory area >(<Condition operator >)(<Value >)
Element Content
Target I/O memory area Specify the target I/O memory area in its type and
address.
Condition operator For Word Condition, a condition operator exists.
Value For I/O Condition, set ON/OFF/NOT, for Word Con-
dition the fixed value (BIN), and for NOT operator of
Word Condition nothing.
Condition operators (and values for I/O Condition) to be set are shown below.
I/O Condition Value Contents
ON The bit value is ON(1)
OFF The bit value is OFF(0)
NOT Hold if the value is changed.
Word Condition
Operator
Contents
= Hold if the value is the same as that of the target I/O
memory area.
< Hold if the value is smaller than that of the target I/O
memory area.
> Hold if the value is greater than that of the target I/O
memory area.
<= Hold if the value is equal to or smaller than that of the
target I/O memory area.
>= Hold if the value is equal to or greater than that of the
target I/O memory area.
<> Hold if the value is not equal to that of the target I/O
memory area.
NOT Hold if the value has been changed.
AUDIN - 8, avenue de la malle - 51370 Saint Brice Courcelles - Tel : 03.26.04.20.21 - Fax : 03.26.04.28.20 - Web : http: www.audin.fr - Email : info@audin.fr

Table of Contents

Other manuals for Omron CS Series

Questions and Answers:

Omron CS Series Specifications

General IconGeneral
ManufacturerOmron
CategoryNetwork Hardware
MountingDIN Rail
TypePLC
SeriesCS Series
Programming LanguageLadder Diagram, Instruction List, Function Block Diagram, Structured Text, Sequential Function Chart
Communication PortsEthernet
Protocols SupportedModbus, Ethernet/IP
Power Supply24V DC or 100-240V AC
Operating Temperature0°C to 55°C
Storage Temperature-25°C to 65°C
Humidity Range10% to 90% (non-condensing)
Vibration Resistance10 to 57 Hz, 0.075 mm amplitude; 57 to 150 Hz, 1 G
Shock Resistance150 m/s² (15 G) in X, Y, and Z directions 3 times each

Related product manuals