Omron E3X-DA-N - Analog Output vs. Distance (Standard Mode); Parallel Operating Range (Mark Detection); Operating Range (Convergent Reflective Fibers)

A-432 Advanced Photoelectric Sensors
Twin-output models
TEACH
Setting the
operating mode
Changing the
operating mode
L ON
D ON
Sensing function Displayed as "F".
Standard
(factory-set)
Area
Super-long distance
Super-high speed
Digital incident level display
OFF
(Factory-set)
Peak
Bottom
Timer function Displayed as "t".
0
(Factory-set)
Adjustable in 1-ms units for 0
to 20 ms and in 5-ms units
for higher.
200
Flashing setting Displayed as "L".
OFF
(Factory-set)
ON
Hold setting Displayed as "H".
Reversing display
Standard
(Factory-set)
Reverse
(Factory setting)
L ON
D ON
(Factory setting)
Setting Functions in SET Mode4
The operating mode for the channel set
with the channel-selection switch can be
changed.
SET
CH1 CH2
Changed using the channel-selection switch
Channel 1 Channel 2
2s
MODE
TEACH
TEACH
TEACH
TEACH
TEACHTEACH
@ Area Sensing
Area sensing is possible using the threshold values
for channels 1 and 2.
· If channel 1 is set to L/ON, output turns ON when
the incident level is between the thresholds.
· If channel 1 is set to D/ON, output turns OFF
when the incident level is between the thresholds.
The result is output to control output 1.
(Control output 2 is always OFF.)
2s
2s
2s
TEACH
TEACH
TEACH
MODE
MODE
MODE
TEACH
TEACH
TEACH
TEACH
2s
TEACH
TEACH
MODE
Set the mode selector
to .
SET
(A)(B)
(A)(B)
Display orientation
setting
There are four different sensitivity settings. Refer to page AB- for
details.