A-420 Advanced Photoelectric Sensors
Power consumption reduced by 70%.
Power consumption has been
reduced up to about 70%
from 1800 mW to 600 mW. (If
the digital display is off)
The digital display can be changed to full-
OFF or Dark-ON during RUN.
Power consumption can be reduced by setting the display to Full-
OFF/Dark-ON in applications where the digital display is rarely
looked at during RUN.
(Can be set at the Mobile Console only)
Beeper-sized, new-generation Mobile Console
unleashing the power of the ultimate fiber amplifier
Remote setting/adjustment function
Incident level and threshold can be displayed simultaneously.
Simultaneous turning possible using group teaching.
Differences in incident light avoided by group zero-reset.
Sensor head flashing during Amplifier operation
Alternatively, the amplifier channel can be displayed.
Previous models E3X-DA-N
(Digital display not lit)
600mW
1800mW
This ECO label is indicated on
products that meet the environmental
standards established by OMRON.
Eco mode
Setting/teaching/fine adjustment can
be made at the fiber front-end.
The Mobile Console has enabled
setting and teaching at the fiber
front-end, which could only be
made at the amplifier. You can
perform major adjustments while
looking at the work position, etc.
Head
Function indicator
Incident level monitor
Channel settings
Threshold display
Operation keys
Battery monitor
Optical
communications
1ch
2ch
3ch
4ch
5ch
New
Concept
Patent
pending
While teaching had to be
performed for each Amplifier
separately, it can now be
performed for several Ampli-
fiers at once using the Mo-
bile Console.
The incident levels of sever-
al amplifiers can be batch-
reset to zero by the group
zero-reset. This feature is
useful for reducing differenc-
es between the amplifiers.
Group teaching
If the amplifier being operat-
ed is away from the sensor
head, the sensor head can be
flashed or the amplifier chan-
nel can be displayed.
To Next Page
Loading...
