E3ZM-V
9
Nomenclature
Safety Precautions
Refer to Warranty and Limitations of Liability on page 15.
This product is not designed or rated for
directly or indirectly ensuring safety of
persons. Do not use it for such a purpose.
Do not use the product with voltage in excess
of the rated voltage. Excess voltage may result
in malfunction or fire.
Never use the product with an AC power
supply. Otherwise, explosion may result.
When cleaning the product, do not apply a
high-pressure spray of water to one part of the
product. Otherwise, parts may become
damaged and the degree of protection may be
degraded.
The following precautions must be observed to ensure safe
operation of the Sensor.
Operating Environment
Do not use the Sensor in an environment where explosive or
flammable gas is present.
Connecting Connectors
Be sure to hold the connector cover when inserting or
removing the connector.
When using an XS3F Connector, be sure to tighten the
connector lock by hand; do not use pliers or other tools.
If the tightening is insufficient, the degree of protection will not
be maintained and the Sensor may become loose due to
vibration. The appropriate tightening torque is 0.3 to 0.4 N·m.
When using another, commercially available connector, follow
the usage and tightening torque instructions provided by the
manufacturer.
Load
Do not use a load that exceeds the rated load.
Low-temperature Environments
Do not touch the metal surface with your bare hands when the
temperature is low. Touching the surface may result in a cold
burn.
Oily Environments
Do not use the Sensor in oily environments. They may
damage parts and reduce the degree of protection.
Modifications
Do not attempt to disassemble, repair, or modify the Sensor.
Outdoor Use
Do not use the Sensor in locations subject to direct sunlight.
Cleaning
Do not use thinner, alcohol, or other organic solvents.
Otherwise, the optical properties and degree of protection
may be degraded.
Cleaning
Do not use highly concentrated cleaning agents. Otherwise,
malfunction may result. Also, do not use high-pressure water
with a level of pressure that exceeds the stipulated level.
Otherwise, the degree of protection may be reduced.
Surface Temperature
Burn injury may occur. The Sensor surface temperature rises
depending on application conditions, such as the ambient
temperature and the power supply voltage. Use caution when
operating or performing maintenance on the Sensor.
Cable Bending
Do not bend the cable in temperatures of −25°C or below.
Otherwise, the cable may be damaged.
WARNING
Teaching Models
Stability indicator
(green)
Teaching indicator
(red)
Operation indicator
(yellow)
Teaching button
CAUTION
Precautions for Safe Use
To Next Page
Loading...
Need help?
General
