Omron E5CC - Page 17

Simplicity on the Worksite Solutions Guide for FAQs: E5CC/E5EC
Setting Temperature Alarms
4-3
Setting Temperature Alarms
Available Alarm Types
You select the alarm type according to the required conditions.
Alarm Type
No. Name
Operation
Do you want
to link the
alarm
temperature
to the set
point?
Do you need
a standby
sequence?
In what
cases do
you want to
output an
alarm?
Set this number in the Temperature
Controller
You use these numbers for the following Alarm Type
parameters: alt1 (ALT1), alt2 (ALT2), alt3 (ALT3), and
alt4 (ALT4).
Refer to page 4-6 for the procedure.
- - None
⇒
0
No alarm
Set this alarm type when you do
not need an alarm.
⇒
1
Upper-limit and
Lower-limit
Alarm
⇒
2
Upper-limit
Alarm
⇒
3
Lower-limit
Alarm
⇒
4
Upper-limit and
Lower-limit
Range Alarm
⇒
5
Upper-limit and
Lower-limit
Alarm with
Standby
Sequence
⇒
6
Upper-limit
Alarm with
Standby
Sequence
⇒
7
Lower-limit
Alarm with
Standby
Sequence
ON
ON
Temperature
SP
Lower limit value
ON
OFF
Upper limit value
Temperature
SP
ON
OFF
Upper limit value
ON
Temperature
SP
Lower limit value
ON
OFF
ON
Temperature
SP
ON
OFF
ON
Lower limit value Upper limit value
ON
ON
Temperature
SP
Lower limit value
ON
OFF
U
pp
er limit value
Temperature
SP
ON
OFF
Upper limit value
ON
Temperature
SP
Lower limit value
ON
OFF
ON
Simplicity on the Worksite Solutions Guide for FAQs: E5CC/E5EC