What to do if temperature error is large on Omron Controller (S.Err display)?
If you are seeing a large temperature error or an S.Err display on your Omron Controller, it may indicate an input type mismatch. Check the sensor type and reset the input type correctly.
How to fix a large temperature error (S.Err display) on my Omron E5CC Temperature Controller?
A large temperature error or an input error (S.Err display) on your Omron Temperature Controller can be caused by an input type mismatch. Check the sensor type and reset the input type correctly. It can also be caused by the thermometer not being installed properly. Check the thermometer installation location and polarity and install correctly.
How to prevent Omron E5CC communication data corruption due to environmental noise?
If the communications data is being corrupted by noise, try using a slower baud rate. Also, separate the communications cable from the source of the noise.
Why can't I always change set points on my Omron E5CC?
If it's sometimes not possible to change the set points or RUN/STOP status on your Omron Temperature Controller, there may be noise interference. Connect terminating resistance to both ends of the communications line.
Why aren't the set points or RUN/STOP status changing for slaves on my Omron E5CC?
If the set points or the RUN/STOP status will not change for any of the slaves, check that: * The wiring to the master (i.e., the Controller with communications unit number 0) is not correct. * The communications settings in the master are not correct.
Why are communications not possible with my Omron Controller?
Communications issues with your Omron Controller may arise if a non-recommended adapter is being used. Ensure that the connected device is not faulty.
Why is my Omron E5CC overshooting, undershooting, or hunting?
Overshooting, undershooting, or hunting can occur with the Omron Temperature Controller if ON/OFF control is enabled. To resolve this, select PID control and execute either ST (self-tuning) or AT (auto-tuning). When using self-tuning, turn ON the power supply to the Digital Controller and load (heater, etc.) at the same time, or turn ON the load power supply first. Also, check if the control period is too long compared to the speed of temperature changes and shorten it if necessary. Unsuitable PID constants can also cause this issue; set appropriate PID constants using either autotuning or manual settings. Finally, investigate any errors detected by the HS alarm function and use breeder resistance if leakage current is the problem.
What to do if the temperature is not rising on my Omron Temperature Controller?
If the temperature isn't rising on your Omron Temperature Controller, it might be due to the specified operation being unsuitable for the required control. The default is reverse operation, so select either forward or reverse operation depending on what you need. Also, check the heater for burnout or deterioration.
How to fix incorrect communications wiring on Omron Temperature Controller?
If the communications wiring is not correct on your Omron Temperature Controller, correct the wiring.
What to do if the Omron Temperature Controller communication line is disconnected?
If the communications line has become disconnected on your Omron Temperature Controller, connect the communications line securely and tighten the screws.
General| Number of Display Digits | 4 digits |
|---|---|
| Number of Control Outputs | 1 |
| Control Method | ON/OFF |
| Input Type | Thermocouple, RTD, Analog voltage, Analog current |
| Supply Voltage | 100 to 240 VAC |
| Output Type | Relay, Voltage, Current |
| Display Type | LCD |
| Size | 48 x 48 mm |
| Mounting Method | Panel mount |
| Control Output | Relay, Voltage, Current |
| Alarm Output | Relay |
| Communication | RS-485 |
| Ambient Operating Temperature | -10 to 55°C |
| Ambient Operating Humidity | 25% to 85% RH |
| Protection Rating | IP66 |
To Next Page
