Omron E5CC - Page 18

Simplicity on the Worksite Solutions Guide for FAQs: E5CC/E5EC
Setting Temperature Alarms
4-4
Setting Temperature Alarms
Alarm Type
No. Name
Operation
Do you want
to link the
alarm
temperature
to the set
point?
Do you need
a standby
sequence?
In what
cases do
you want to
output an
alarm?
Set this number in the Temperature
Controller
You use these numbers for the following Alarm Type
parameters: alt1 (ALT1), alt2 (ALT2), alt3 (ALT3), and
alt4 (ALT4).
Refer to page 4-6 for the procedure.
⇒
8
Absolute-value
Upper-limit
Alarm
⇒
9
Absolute-value
Lower-limit
Alarm
⇒
10
Absolute-value
Upper-limit
Alarm with
Standby
Sequence
⇒
11
Absolute-value
Lower-limit
Alarm with
Standby
Sequence
* Refer to the E5CC/E5EC Digital Temperature Controllers
User's Manual (Cat. No. H174) for information on alarm types
12 (LBA) to 19 (RSP Absolute-value Lower-limit Alarm).
Temperature
ON
OFF
Alarm value
0
ON
ON
ON
OFF
0
Temperature
Alarm value
ON
OFF
0
ON
Temperature
Alarm value
ON
ON
OFF
0
Temperature
Alarm value
Simplicity on the Worksite Solutions Guide for FAQs: E5CC/E5EC