E8F
E8F
9
Precautions
Correct Use
Available Gases:
No corrosive or flammable gas can be used.
Filter
the gas with an appropriate air filter so that the applied gas will
be
free of moisture or oil.
Make sure that the pressure applied is within the rated range.
If
the silicone diaphragm is damaged, the E8F will not operate prop
-
erly.
Do not insert a screwdriver or steel wire into the interior of the
pressure-sensitive
parts through the pressure leading part.
The
E8F has a display error of
±
3% FS
±
1 digit at the time of ON or
OFF point setting at room temperature. If a
highly precise pressure
setting
is required, use a manometer
.
Nullify the ON/OFF output at the time of error detection.
If
the use of the E8F requires the
IP66 enclosure rating (e.g., wash
-
ing the E8F with water), be sure to connect a standard silicone tube
to
the atmosphere inlet. The silicone tube must have
a 2-mm inner
diameter
and 4-mm outer diameter
.
Reset Time:
The E8F is ready to operate within 200 ms after the E8F is turned
ON.
Make sure that the Sensor is free from ultrasonic vibration when
mounting
the E8F
.
Others:
If
no linear or error output is used, cut of
f the black and orange lead
wires
and apply insulation tape to the lead wires so that they will not
come
in contact with any other terminal.
To Next Page
Loading...
