F3SJ-A
8
Setting Tools *1
*1. The setting tools described above can be connected only to F3SJ-A models with built-in software of Ver. 2 or later.
Note that the setting tools cannot be used with products shipped prior to December 2005.
The setting tools cannot be used for setting parameters on the F3SJ-A@-TS series, but the monitoring function can be used.
*2. The PC tool supports Windows XP/7.
*3. This product is for use only with the F3SJ-A.It cannot be connected to conventional models of the F3SJ-E/B or F3SN-A series.
Protective Bar *1 *2
*1. This product is for F3SJ-A only.
*2. When using for both emitter and receiver, order two sets.
*3. The same four digits indicating protective height that are used in the Sensor model number (@@@@) are used in the part of the Protector model number.
Water-resistant Case (Set of 1 tube, packing, and dedicated connector cable) *1 *2 *3
*1. This product is for F3SJ-A only.
*2. When using for both emitter and receiver, order two sets.
*3. There are restrictions to the application conditions depending on the protective height of the Curtain. Refer to the Water-resistant Case on page 77.
*4. The same four digits indicating protective height that are used in the Sensor model number (@@@@) are used in the part of the Protector model number.
*5. Be sure to purchase brackets with the Case to match the mounting direction (rear or side).
Type Appearance Model Remarks
"SD Manager"
Setting Support
Software for the
F3SJ
F39-GWUM *2
Accessories:
SD Manager CD-ROM (1),
F39-CN1 Branch Connector (1),
Connector Cap (1),
2-m Dedicated Cable (1
),
0.3-m Dedicated Cable with Plug (1),
I
nstruction Manual
Setting Console F39-MC21 *3
Accessories:
F39-CN1 Branch Connector (1),
Connector Cap (1),
2-m Dedicated Cable (1
),
0
.3-m Dedicated Cable with Plug (1)
,
I
nstruction Manual
Type Appearance Model Remarks
Protective Bar F39-PJ@@@@-S *3
Main unit bracket (1),
rear mounting brackets (2),
including intermediate brackets to match protective
height (0 to 2).
Intermediate
brackets for side
mounting
F39-PJ-MS
For side mounting, order to suit the desired protective height.
Protective height of up to 1,000 mm: 0 intermediate brackets
Protective height of 1,001 to 2,000 mm: 1 intermediate
bracket
Protective height of 2,001 mm or more: 2 intermediate
brackets
Appearance Specifications Model Remarks
For emitter F39-EJ@@@@-L *4 Includes gray cable for emitter.
For receiver F39-EJ@@@@-D *4 Includes black cable for receiver.
Rear Mounting Brackets F39-EJ-R *5 Top/bottom 1 each, total of 2
Side Mounting Brackets F39-EJ-S *5 Top/bottom 1 each, total of 2
---
Series connection cable (for emitter)
F39-JJR3WE-L
Purchase additionally for series connection when using
the Water-resistant Case.
Series connection cable (for receiver)
F39-JJR3WE-D
To Next Page
Loading...
