Omron GO SMART HJ-203 - Battery Replacement Process; Removing Battery Cover and Battery; Inserting and Securing New Battery

1211
BATTERY REPLACEMENT
1. Loosen the screw of the battery cover
on the back of the unit, and remove
the battery cover by pulling it off in the
direction of the arrow.
Use the supplied screwdriver or use a small
screwdriver to loosen the screw on the battery cover.
2. Remove the battery with a thin, sturdy,
stick that will not break easily.
Take the battery out with a thin stick that will not
break easily.
NOTE:
DO NOT use a pair of metal tweezers or a
screwdriver.
CAUTION
Dispose of the device, battery, and
components according to applicable local
regulations. Unlawful disposal may cause
environmental pollution.
CAUTION
Do not throw the battery into re. The
battery may explode.
BATTERY REPLACEMENT
3. Insert the battery (CR2032) with the
positive (+) side face up.
4. Replace the battery cover by sliding the
catch in rst, then tighten the screw.