Omron H5CC - Page 31

3131
H5CC
Twin Timer
Timing Charts
Operating Procedures for Twin Timer Function
Models Other than the H5CC-L8E@
The gate input is not included in the H5CC-L8@ models.
Mode toff: Flicker OFF start I (Timer resets when power comes ON.)
Basic operation Detailed operation
* Start signal input is disabled during timing.
Timing starts when the start signal goes ON.
The status of the control output is reversed when time is
up (OFF
at start).
While the start signal is ON, the Timer starts when the
power comes ON or when t
he reset input goes OFF.
Note: Normal
ou
tput operation will not be possible if
the set time is too short.
Set the ON time and OFF time to at least 100 ms
(contact ou
tput type).
Mode ton: Flicker ON start I (Timer resets when power comes ON.)
Basic operation Detailed operation
* Start signal input is disabled during timing.
Timing starts when the start signal goes ON.
The status of the control output is reversed when time is
up (ON at
start).
While the start signal is ON, the Timer starts when the
power
comes ON or when t
he reset input goes OFF.
Note: Normal ou
tput operation will not be possible if
the set time is too short.
Set the ON time and OFF time to at least 100 ms
(cont
act ou
tput type).
Mode toff-1: Flicker OFF start II (Timer does not reset when power comes ON.)
Basic operation Detailed operation
* Start signal input is disabled during timing.
Timing starts when the start signal goes ON.
The status of the control output is reversed when time is
up (OFF
at start).
While the start signal is ON, the Timer starts when the
power comes ON or when t
he reset input goes OFF.
Note: Normal
ou
tput operation will not be possible if
the set time is too short.
Set the ON time and OFF time to at least 100 ms
(contact ou
tput type).
Power
Output
*
Start signal
input
Timing
OFF
Timing
ON
Timing
OFF
Timing
ON
ON time
OFF time
0
OFF time
ON time
0
UP
DOWN
Power
Start signal
Gate
Reset
Control output
Timing diagram
Power
Output
*
Start signal
input
Timing
ON
Timing
OFF
Timing
ON
Timing
OFF
0
0
ON time
OFF time
OFF time
ON time
UP
DOWN
Power
Start signal
Gate
Reset
Control output
Timing diagram
Power
Output
*
Start signal
input
Timing
OFF
Timing
ON
Timing
OFF
(a + b = ON time)
ab
0
0
ON time
OFF time
OFF time
ON time
UP
DOWN
Power
Start signal
Gate
Reset
Control output
Timing diagram