USING THE TruRead
™
MODE
1. Select your USER ID (A or B).
2. Press the START/STOP button.
All symbols appear on the display. The USER ID Symbol
you selected flashes on the display.
The cuff starts to inflate automatically.
NOTE: To stop the inflation or measurement, press the
START/STOP button. The monitor will stop
inflating, start deflating and will turn off.
3. Inflation stops automatically and the measurement is started.
As the cuff deflates, decreasing numbers appear on the display.
The Heartbeat Symbol ( ) flashes at every heartbeat. When
the measurement is complete, the arm cuff completely deflates.
NOTE: Do not move your arm and remain still until the entire
measurement process is completed.
4. Check the progress of the consecutive measurements.
NOTE: If a measurement fails, the monitor will repeat taking
a measurement up to five times during the consecutive
measurement process.
The first measurement is complete, waiting to start the next
measurement. The interval of time set between each
measurement will appear on the display.
TAKING A MEASUREMENT
33
HEM-7080-updated Sept 22.qxd 9/22/06 3:46 PM Page 33
To Next Page
Loading...
