16 Before Using The Unit
1. Remove the screw on the battery cover
with a Phillips screwdriver.
2. Open the battery cover and remove the
worn battery.
Do not use metal tweezers or a screw-
driver to remove the battery.
3. Insert a new battery with the correct align-
ment of polarities as shown in the figure.
4. To close the cover, fit the claws of
the battery cover into the grooves until
they click.
5. Fasten the screw to the battery cover.
NOTES:
• Use a LR43 type battery.
• Replace the worn battery with a new one immediately.
• Dispose of worn battery properly.
When to replace the battery
Replace the battery with a new one (LR43) when a
mark blinks.
• Once the battery is removed, all the memory data and the
set data (time weight, and stride distance) are deleted.
Set time, weight, and stride distance again.
• Please record any important data on your notepad
before installing a new battery.
Replacement of Battery
How To Use The Unit
EN-02-19[HJ109]-8 7/1/03, 4:18 PM16
To Next Page
Loading...
Need help?
General
