Omron IntelliSense IW2 - Monitor Care and Maintenance; Care and Protection Guidelines

Troubleshooting
19
Error Symbol Cause Correction
Cuff over inflated.
Press the START/STOP
button once to turn off
the power. Sit still restart
measurement and keep
still and do not talk
during measurement.
Movement during
measurement
The wrist cuff is not
fastened securely.
Carefully read and
repeat the steps listed
under “How to Apply the
Wrist Cuff”.
An E mark is
displayed.
Contact the store where
you purchased this unit,
or the nearest OMRON
dealer.
After several seconds
After several seconds
The battery power is
low.
Replace the batteries
with two new “AAA”
batteries.
Wrist is not in the
correct position.
Carefully read and
repeat the steps in “How
to Take a Reading”.
Make sure that the
setting is set correctly for
the wrist being used to
take the measurement.
(See page 16.)
EN[IW2]-2 3/14/05 5:22 PM Page 19