Omron IntelliSense IW2 User Manual

How to Modify the Settings
You can modify the options for the various settings of your monitor. This is
done by pressing the SET button to select a setting, then pressing the MEM
button to select the options for that setting. After selecting a setting, press the
START/STOP button to turn the power off.
Turning the Position Sensor On/Off
1. Press the SET button until the Position Sensor
Symbol ( ) appears on the display.
2. Press the MEM button to select “on” or “oFF”. When “on” is selected, the
monitor displays symbols to indicate how close your wrist is to the correct
measuring position.
Setting the Position Sensor Alarm
1. Press the SET button until the Position Sensor
Alarm Symbol ( ) appears on the display.
The default settings is “on1”, and this emits a
series of two short blips if your wrist is too far
away from the measuring position, and beeps
slowly when you wrist is in the correct position. When “on2” is selected
the alarm only beeps when your wrist is in the correct position.
16
EN[IW2]-2 3/14/05 5:22 PM Page 16

Omron IntelliSense IW2 Specifications

Display

display type	LCD Digital Display

Measurement

measurement method	Oscillometric method
measurement range pressure	0 to 299 mmHg
pulse range	40 to 180 beats/min

Accuracy

pressure accuracy	Within ±3 mmHg
pulse rate accuracy	Within ±5% of reading

Power Supply and Battery

power supply	Two AAA batteries (LR03)
battery life	Approximately 300 measurements

Operating Environment

operating temperature	10°C to 40°C
operating humidity	30 to 85% RH

Storage Conditions

storage temperature	-20°C to 60°C
storage humidity	10 to 95% RH

Weight and Dimensions

weight	Approximately 110 g
width	70 mm
height	54 mm
depth	37 mm