K3TJ
K3TJ
15
Precautions
Mounting
Recommended panel thickness is 1 to 3.2 mm.
Mount the K3TJ by attaching the mounting bracket supplied as an
accessory from the rear of the K3TJ. Turn each mounting screw
clockwise and tighten it to a torque of 5 kgf
$
cm (0.49N
$
m).
Mount the K3TJ as horizontally as possible.
Never use the K3TJ in locations where corrosive gas (particularly
sulfuric or ammonia gas) exists.
Avoid use of the K3TJ in locations subject to severe shock or vibra-
tion, excessive dust, or excessive moisture.
Select mounting locations where the ambient operating tempera-
ture is --10
#
Cto55
#
C.
Others
When selecting parameters or making settings, the front panelcov-
er should be removed. Do not touch parts other thanthe DIP switch
andkeyswith yourhandorametalobject,especiallywhen theK3TJ
is turned ON.
To Next Page
Loading...
