Omron M1 Classic - Preparation Steps; Inserting Batteries; Fitting the Blood Pressure Cuff

3
M1 Classic English
3 Preparation
1 Slide off the battery cover. 2 Insert four batteries as indicated and
close the battery compartment.
Caution! Use four identical 1.5V
alkaline batteries type AA LR6!
Insert batteries
Assemble air tube
1 Connect the air tubes to the air plugs.
Fit cuff
Caution! Do not inflate the cuff when not
wrapped around the arm!
1 Bare your arm.
Caution! Push up your sleeve: avoid
constricting the blood flow!G Air tube
J Ring
J
G
2 Pass the end of the cuff through the ring.
Caution! Keep the air tube on the
outside!
3 Put your arm through the loop.
Note: keep the tube even with your
middle finger.
1-2 cm
28070122-03 Manual M1 GB 01-12 28-11-2008 09:19 Pagina 3