Omron M1 Classic - Error: Causes and Corrections; Maintenance and Spare Parts

Indication Error Cause Correction
Correct reading Cuff pressure low
1
Wait for at least three
not possible minutes to repeat
Movement measurement.
Inflate the cuff
Very weak artery 40 mmHg higher
1
/
pulse 30 mmHg lower
2
than previous value.
Cuff pressure Follow instructions,
too high
2
repeat measurement
Air pressure Air pressure Press air release button
in cuff not released
Low voltage Batteries weak/ Fit four new identical
exhausted 1.5V alkaline batteries
type AA LR6
Display empty
8
M1 Classic English
6 Error: causes and corrections
• Use a soft, slightly moistened cloth to
clean the OMRON M1 Classic.
Caution! Do not use petrol, thinners or
similar solvents!
• Use a soft, moistened cloth and soap
to clean the cuff.
Caution! Do not wash the cuff!
Caution! Do not use petrol, thinners or
similar solvents!
• Do not carry out repairs of any kind
yourself. If a defect occurs consult your
OMRON retail outlet or distributor as
mentioned on the packaging.
Calibration
• It is recommended to have the OMRON
M1 Classic inspected every two years
to ensure correct function and
accuracy. Consult your OMRON retail
outlet or OMRON distributor as
mentioned on the packaging.
Replace batteries
• Remove the battery out of the battery
7 Maintenance and spare parts
28070122-03 Manual M1 GB 01-12 28-11-2008 09:19 Pagina 8