Omron NJ Series Network Connection Guide

4. Overview
5
4. Overview
This document describes the procedure for connecting the Displacement Sensor (ZW series)
of OMRON Corporation (hereinafter referred to as OMRON) to NJ-series Machine Automation
Controller (hereinafter referred to as the Controller) via EtherNet/IP and provides the
procedure for checking their connection.
Specifically, it describes the procedure for connecting EtherNet/IP using the EtherNet/IP
settings of the project file that was prepared beforehand (hereinafter referred to as the
"procedure for using the configuration files").
Section 9 A-1 and Section 10 A-2 describe the procedures for setting parameters with
software without using files (hereinafter referred to as the "procedure for setting parameters
from beginning".
To follow the "procedure for using configuration files", obtain the latest "Sysmac Studio project
file" and "Network Configurator v3 network configuration file" (they are referred to as
"configuration files") from OMRON in advance.
Name File name Version
Sysmac Studio project file
(extension: smc)
OMRON_ZW_EIP_EV100.smc Ver.1.00
Network Configurator v3 network
configuration (extension: nvf)
OMRON_ZW_EIP_EV100.nvf Ver.1.00

Omron NJ Series Specifications

General

Program Capacity	Up to 128 MB
SD Card Slot	Yes
Power Supply Voltage	24 VDC
Motion Control	Yes
USB Ports	1
Operating Temperature	0°C to 55°C
Communication Interfaces	Ethernet/IP, EtherCAT, USB
Safety Function	Optional
Storage Temperature	-20°C to 75°C
Communication Ports	USB
Dimensions	Varies by model
Weight	Varies by model