Omron NJ Series

5．Applicable Devices and Device Configuration
7
Precautions for Correct Use
Update the Sysmac Studio to the version specified in this section or higher version using the
auto update function.
If a version not specified in this section is used, the procedures described in Section 7 and
subsequent sections may not be applicable. In that case, use the equivalent procedures
described in the Sysmac Studio Version 1 Operation Manual (Cat. No. W504).
Additional Information
For information on the specifications of the Ethernet cable and network wring, refer to Section
4 EtherCAT Network Wiring of the NJ-series CPU Unit Built-in EtherCAT Port User's Manual
(Cat. No. W505).
Additional Information
The system configuration in this document uses USB for the connection to the Controller.
For information on how to install a USB driver, refer to A-1 Driver Installation for Direct USB
Cable Connection of the Sysmac Studio Version 1 Operation Manual (Cat. No. W504).