Omron NJ Series - Page 26

7．EtherCAT Connection Procedure
23
6
Select Online from the
Controller Menu.
7
Select Synchronization from
the Controller Menu.
8
The Synchronization Dialog Box
is displayed.
Confirm that the data to transfer
(NJ501 in the right dialog) is
selected. Then, click the
Transfer To Controller Button.
* After executing the Transfer To
Controller, the Sysmac Studio
data is transferred to the
Controller and the data is
compared.
9
A confirmation dialog box on the
right is displayed. Confirm that
there is no problem and click the
Yes Button.
A screen stating "Synchronizing"
is displayed.
A confirmation dialog box on the
right is displayed. Confirm that
there is no problem and click the
No Button.
* Do not return it to RUN mode.