3-139
3 Error Tables
NJ-series Troubleshooting Manual (W503)
3-2 Events in Order of Event Codes
3
3-2-2 Error Table
94070000 hex Tag Data Link All Run Built-in EtherNet/IP Port on CPU Unit W506
94080000 hex IP Address Fixed Built-in EtherNet/IP Port on CPU Unit W506
94090000 hex BOOTP Client Started Built-in EtherNet/IP Port on CPU Unit W506
940A0000 hex FTP Server Started Built-in EtherNet/IP Port on CPU Unit W506
940B0000 hex NTP Client Started Built-in EtherNet/IP Port on CPU Unit W506
940C0000 hex SNMP Started Built-in EtherNet/IP Port on CPU Unit W506
94200000 hex Notice of Insufficient Travel Distance
to Achieve Blending Transit Velocity
General Motion Control W507
94210000 hex Error Clear from MC Test Run Tab
Page
General Motion Control W507
94220000 hex Slave Error Code Report General Motion Control W507
94400000 hex Slave Disconnected Built-in EtherCAT Master in CPU Unit W505
94410000 hex Slave Connected Built-in EtherCAT Master in CPU Unit W505
94430000 hex Errors Reset Built-in EtherCAT Master in CPU Unit W505
94440000 hex* Slave Disabled Built-in EtherCAT Master in CPU Unit W505
94450000 hex* Slave Enabled Built-in EtherCAT Master in CPU Unit W505
98010000 hex Absolute Value Cleared Servo G5 I576
98020000 hex Position Data Initialized Servo G5 and G5 Linear I576, I577
Event code Event name Functional classification Reference
To Next Page
Loading...
