5-93
5 Troubleshooting
NJ-series CPU Unit Hardware User’s Manual (W500)
5-2 Troubleshooting
5
5-2-4 Error Descriptions
*1 This event code occurs for unit version 1.11 or later of the CPU Unit.
Event name SD Memory Card Program Transfer Completed Event code
90210000 hex
*1
Meaning Transferring the SD Memory Card programs was completed.
Source PLC Function Module Source details None Detection
timing
When transfer-
ring SD Memory
Card programs is
completed
Error attributes Level Information Recovery --- Log category System
Effects User program --- Operation Not affected.
System-defined
variables
Variable Data type Name
_Card1PrgTransferSta _sPRGTRANSFER_STA SD Memory Card Program Transfer
Status
Cause and
correction
Assumed cause Correction Prevention
Transferring the SD Memory Card
programs was completed.
--- ---
Attached
information
None
Precautions/
Remarks
None
To Next Page
Loading...
