To Next Page

To Previous Page

5-1 Connecting to Host Via Ethernet

Reference

• The node number cannot be set to a value higher than 7E (126 decimal). If the node

number is set to a higher value, an error will occur and the ERH indicator in the dis-

play will light.

• Set the node numbers so that all the nodes in the same network are unique.

Setting IP Addresses for Ethernet Units

The IP address must also be set for Ethernet Units. Ethernet communications are not possi-

ble if the IP address of the Ethernet Unit is not set.

Set the IP address for the Ethernet Unit from the CPU Bus Unit Setup Area using Program-

ming Devices (SYSMAC-CPT, SYSMAC Support Software, CV Support Software Ver. 2 or

later, FIT20-MF501-V2, FIT10-MF501-V2, FIT20-MC601, or FIT20-MC701). Refer to the

SYSMAC CVM1/CV Series Ethernet Unit Operation Manual (W242) for details on setting

methods.

Ethernet Unit System

Set the system settings for the Ethernet Unit to operate on the Ethernet network as a node.

Set the system settings using a Programming Device (SYSMAC-CPT, SYSMAC Support

Software, CV Support Software Ver.2 or later, FIT20-MF501-V2

、FIT10-MF501-V2, FIT20-

MC601, or FIT20-MC701).

Reference

• For details on operating the Support Software, refer to the CPU Bus Unit Setup Area

in the SYSMAC Support Software Operation Manual: Networks (W201) and SYSMAC

Support Software Operation Manual: CV Series (W249).

• Turn ON the power to the CPU Unit again after setting the system settings. The sys-

tem settings are not enabled after setting them until the power has been turned ON

again.

5-14

Omron ns series Setup Manual

Other manuals for Omron ns series