Omron NX-EC0112

10 - 23
10 Troubleshooting
NX-series Position Interface Units User’s Manual (W524)
10-3 Checking for Errors and
Troubleshooting on the Sysmac
10
10-3-2 Event Codes for Errors and Troubleshooting Procedures
Event name Event Log Cleared Event code 90400000 hex
Meaning The event log was cleared.
Source
Depends on where the Sysmac
Studio is connected and the sys-
tem configuration.
Source details
NX Unit
Detection
timing
When com-
manded from
user
Error
attributes
Level
Information
Recovery
---
Log category
Access
Effects User program Continues. Operation Not affected.
Sys-
tem-defined
variables
Variable Data type Name
None --- ---
Cause and
correction
Assumed cause Correction Prevention
The event log was cleared by the
user.
--- ---
Attached
information
Attached information: Events that were cleared
1: The system event log was cleared.
2: The access event log was cleared.
Precautions/
Remarks
None