Omron NX Series Network Connection Guide

11 Initialization
45
11. Initialization Method
This document presumes that the device is in the factory default state.
When using a device that has been changed from its initial setting state, programming
sometimes cannot be proceeded with according to the procedure.
To set the controller to the initial setting state, the CPU Unit must be initialized.
Set the operating mode of the controller to the program mode, and select Controller - Clear
All Memory... from the Sysmac Studio menu bar. The Clear All Memory... dialog box is
displayed. Check the content of the dialog box, and click OK.
11.1. Initializing the Controller

Omron NX Series Specifications

General

Brand	Omron
Model	NX Series
Category	Controller
Language	English